Disclosure of Material Connection: I have not received any compensation for writing this post. I have no material connection to the brands, products, or services that I have mentioned. I am disclosing this in accordance with the Federal Trade Commission's 16 CFR, Part 255: "Guides Concerning the Use of Endorsements and Testimonials in Advertising."
DIY Valentine’s Day Mesh Wreath decoration for your home.
Spencer and I were out shopping for craft supplies, and I stumbled upon mesh ribbon. I am sure you have probably seen the gorgeous wreaths made out of it by now they are absolutely beautiful! Since I love making different things, I decided I would give it a try. It is a simple project that requires a little time (less than an hour).
Here is what I used to make mine:
18′ Wire wreath
2 rolls of heart wire ribbon
Chenille stems ?
1 roll red mesh ribbon (21 in wide)
1 roll white mesh ribbon (5 1/2 in wide)
Cut chenille stems in half.
Gather end of red mesh while still on the roll and another section approximately 4″-6″ from end. Pull gathered sections together and tie onto wreath form with chenille stems.
Gather another section approximately 4″-6″ from the last and tie onto wire wreath form.
Continue this until the inside ring is covered. Switch colors after several sections are gathered.
Repeat Steps 3-4 for the outside ring.
Tie end of mesh with a chenille stem to the outside ring where the bow will be.
Make a multi-loop bow with both ribbons and secure center with a chenille stem. Tie onto wire wreath with the chenille stem. Tuck or trim excess chenille stems and / or ribbon.
Run ribbon through wreath, tucking in as desired.
Viola! A gorgeous Valentine’s Day wreath! My wreath is quite big but if you want to create a smaller wreath just get a smaller wire wreath.